清潔的液壓油是液壓系統的生命,，升降平臺液壓系統中有許多精密偶件,，有的有阻尼小孔,、有的有縫隙等,。若固體雜質入侵將造成精密偶件拉傷,、發卡,、油道堵塞等,，危及液壓系統的安全運行,。

1、升降平臺液壓油必須過濾加注,，加油工具應可靠清潔,。不能為了提高加油速度而去掉油箱加油口處的過濾器,。加油人員應使用干凈的手套和工作服，以防固體雜質和纖維雜質掉入油中,。 　　
Hangzhou lifting platform hydraulic oil must be filtered filling, refueling tool should be reliable clean. Not in order to improve the speed and remove the fuel tank fuel filter at the mouth.Refueling should use clean gloves and coveralls to prevent solids and fibrous impurities fall into the oil.

2,、升降平臺養時拆卸液壓油蓋加油蓋、濾清器蓋,、檢測孔,、液壓油管等部位，造成系統油道暴露時要避開揚塵,，拆卸部要先徹底清潔后才能打開,。如拆卸液壓油箱加油蓋時，先除去油箱蓋四周的泥土,，擰松油箱蓋后,，清除殘留在接合部位的雜物（不能用水沖洗以免水滲入油箱），確認清潔后才能打開油箱蓋,。
Removing Hangzhou care when lifting platform hydraulic oil filler cap cover, filter cover, test holes, hydraulic tubing and other parts, causing the system to avoid dust exposure to oil channel,after the demolition of the Department must first be thoroughly cleaned to open. When the hydraulic tank filler cap as demolition, first remove the soil around the tank cover, rear twist pine oil cover, remove the debris left in the joint zone (not rinsed with water to prevent water infiltration tank), confirmed to clean the fuel tank cap can be opened.

3,、如需使用擦拭材料和鐵錘時，應選擇不掉纖維雜質的擦拭材料和擊打面附著橡膠的專用鐵錘,。液壓元件,、液壓膠管要認真清洗，用高壓風吹干后組裝,。選用包裝完好的正品濾芯（內包裝損壞,，雖然濾芯完好，也可能不潔）,。換油時同時清洗濾清器,，安裝濾芯前應用擦拭材料認真清潔濾清器殼內底部污物。 　　
For use when wiping material and hammer, can not afford to wipe material should be selected and the striking face fiber impurities attached special rubber hammer. Hydraulic components, hydraulic hose should carefully cleaned with high pressure blown dry after assembly. Selection of genuine packaging intact filter (within the packaging is damaged, although the filter in good condition, it may unclean). Meanwhile wash the filter oil change, the application materials carefully wipe clean the dirt at the bottom of the filter housing before installing the filter.

4,、升降平臺清洗油必須使用與系統所用牌號相同的液壓油,，油溫在45～80℃之間，用大流量盡可能將系統中雜質帶走,。液壓系統要反復清洗三次以上，每次清洗完后,，趁油熱時將其全部放出系統,。清洗完畢再清洗濾清器、更換新濾芯后加注新油,。
Hangzhou lifting platform cleaning the oil must be used with the system used in the same grade hydraulic oil, the oil temperature between 45 ~ 80 ℃, with a large flow of impurities in the system as far as possible away. Hydraulic system to repeatedly wash more than three times, after each cleaning, the entire release system to take advantage of the oil is hot. Cleaning is completed and then cleaning the filter, add new oil after replacing the new filter.